BQ HeatCore Classic Hot-End
Aluminum mounting plate to connect the standard J-Head Nozzle.
The original J-Head Mk B-BV Hotend, complete with thermistor 100K, 3% for temperature control and resistor for heating up the nozzle. The central bore of 0,35 mm or 0,5 mm allows layer heights from 300 micron to 50 micron.This hotend is compatible with our 1.75 and 3 mm filament..
Original jhead - PTFE 1.75 mm Liner
Original jhead - PTFE 3 mm Liner
Original jhead hollow set screw
Original MK 5 PEEK Nozzle Holder
PTFE tape can allow high temperatures (250 degrees should be no problem), which makes is useful for insulating the extruder or avoiding leakage.
Heater block for K8200 3D Printer
Velleman K8200 Filament Guide Isolator
Hot-End HeatCore DDG made exclusively for the Witbox 2