Languages

Empty

Total: 0,00 €

Arduino 37 in 1 Sensor kit

A comprehensive sensor-kit that is designed to be used in compbination with Arduino-boards.

 

With this kit you can do all kinds off measurements in combination with an Arduino!

The kit contains no less than 37 sensors that are delivered in a handy case.  

 

The kit contains:

 

1 x Active Buzzer Module 

1 x Automatic Flashing Colorful LED Module 

1 x Class magnetic Sensor

48,09 €incl. tax
39,74 €excl. tax

Heater Cartridge 24V/30W 1 pcs

With this heater cartridge you will increase the reliability of your extruder.

 

Details:

  • Voltage: 24 V

  • Power: 30 W

  • Wire length: 1 m

  • Cartridge length: 2.3 cm

  • Cartridge diameter: 6 mm

5,43 €incl. tax
4,49 €excl. tax

Heater Cartridge 12V/30W 1 pcs

With this heater cartridge you will increase the reliability of your extruder.

 

Details:

  • Voltage: 12 V

  • Power: 30 W

  • Wire length: 1 m

  • Cartridge length: 2.3 cm

  • Cartridge diameter: 6 mm

5,43 €incl. tax
4,49 €excl. tax

100k NTC Thermistor with PTFE sleeving

For using this thermistor you need to change your printer's firmware. Choose the standard 100K NTC Thermistor setting usually this is number 1.

 

You can also make your own table by using the calculator from Josef Prusa.

 

Details:

  • Operating Temperature: -40 / +300°C

  • Resistance Tolerance: 1%

  • Technology: Metal Oxide

2,50 €incl. tax
2,07 €excl. tax

5.6 Ohm Heater Resistor with PTFE sleeving 1 pcs

This resistor can be used for heating your Jhead hotend or any other types of hotend that has a ø 5,5 mm hole.

 

Details:

  • Family: Through Hole Resistors

  • Series: UB

  • Resistance: 5.6 Ohm

  • Power: 5 W

  • Composition: Wirewound

  • Temperature Coefficient: ± 50 ppm/°C

  • Tolerance: ± 1%

  • Case: Axial

1,50 €incl. tax
1,24 €excl. tax